# Learning Objectives

### Learning Objectives

By the end of this section, you will be able to do the following:

• Relate the characteristics of waves to properties of sound waves
• Describe the speed of sound and how it changes in various media
• Relate the speed of sound to frequency and wavelength of a sound wave
 rarefaction sound

# Properties of Sound Waves

### Properties of Sound Waves

Sound is a wave. More specifically, sound is defined to be a disturbance of matter that is transmitted from its source outward. A disturbance is anything that is moved from its state of equilibrium. Some sound waves can be characterized as periodic waves, which means that the atoms that make up the matter experience simple harmonic motion.

A vibrating string produces a sound wave as illustrated in Figure 14.2, Figure 14.3, and Figure 14.4. As the string oscillates back and forth, part of the string’s energy goes into compressing and expanding the surrounding air. This creates slightly higher and lower pressures. The higher pressure... regions are compressions, and the low pressure regions are rarefactions. The pressure disturbance moves through the air as longitudinal waves with the same frequency as the string. Some of the energy is lost in the form of thermal energy transferred to the air. You may recall from the chapter on waves that areas of compression and rarefaction in longitudinal waves (such as sound) are analogous to crests and troughs in transverse waves.

Figure 14.2 A vibrating string moving to the right compresses the air in front of it and expands the air behind it.
Figure 14.3 As the string moves to the left, it creates another compression and rarefaction as the particles on the right move away from the string.
Figure 14.4 After many vibrations, there is a series of compressions and rarefactions that have been transmitted from the string as a sound wave. The graph shows gauge pressure (Pgauge) versus distance x from the source. Gauge pressure is the pressure relative to atmospheric pressure; it is positive for pressures above atmospheric pressure, and negative for pressures below it. For ordinary, everyday sounds, pressures vary only slightly from average atmospheric pressure.

The amplitude of a sound wave decreases with distance from its source, because the energy of the wave is spread over a larger and larger area. But some of the energy is also absorbed by objects, such as the eardrum in Figure 14.5, and some of the energy is converted to thermal energy in the air. Figure 14.4 shows a graph of gauge pressure versus distance from the vibrating string. From this figure, you can see that the compression of a longitudinal wave is analogous to the peak of a transverse wave, and the rarefaction of a longitudinal wave is analogous to the trough of a transverse wave. Just as a transverse wave alternates between peaks and troughs, a longitudinal wave alternates between compression and rarefaction.

Figure 14.5 Sound wave compressions and rarefactions travel up the ear canal and force the eardrum to vibrate. There is a net force on the eardrum, since the sound wave pressures differ from the atmospheric pressure found behind the eardrum. A complicated mechanism converts the vibrations to nerve impulses, which are then interpreted by the brain.

# The Speed of Sound

### The Speed of Sound

The speed of sound varies greatly depending upon the medium it is traveling through. The speed of sound in a medium is determined by a combination of the medium’s rigidity (or compressibility in gases) and its density. The more rigid (or less compressible) the medium, the faster the speed of sound. The greater the density of a medium, the slower the speed of sound. The speed of sound in air is low, because air is compressible. Because liquids and solids are relatively rigid and very difficult to compress, the speed of sound in such media is generally greater than in gases. Table 14.1 shows the speed of sound in various media. Since temperature affects density, the speed of sound varies with the temperature of the medium through which it’s traveling to some extent, especially for gases.

Medium vw (m/s)
Gases at 0 °C
Air 331
Carbon dioxide 259
Oxygen 316
Helium 965
Hydrogen 1290
Liquids at 20 °C
Ethanol 1160
Mercury 1450
Water, fresh 1480
Sea water 1540
Human tissue 1540
Solids (longitudinal or bulk)
Vulcanized rubber 54
Polyethylene 920
Marble 3810
Glass, Pyrex 5640
Aluminum 5120
Steel 5960
Table 14.1 Speed of Sound in Various Media

# The Relationship Between the Speed of Sound and the Frequency and Wavelength of a Sound Wave

### The Relationship Between the Speed of Sound and the Frequency and Wavelength of a Sound Wave

Figure 14.6 When fireworks explode in the sky, the light energy is perceived before the sound energy. Sound travels more slowly than light does. (Dominic Alves, Flickr)

Sound, like all waves, travels at certain speeds through different media and has the properties of frequency and wavelength. Sound travels much slower than light—you can observe this while watching a fireworks display (see Figure 14.6), since the flash of an explosion is seen before its sound is heard.

The relationship between the speed of sound, its frequency, and wavelength is the same as for all waves:

14.1$v=fλ,v=fλ,$

where v is the speed of sound (in units of m/s), f is its frequency (in units of hertz), and $λλ$ is its wavelength (in units of meters). Recall that wavelength is defined as the distance between adjacent identical parts of a wave. The wavelength of a sound, therefore, is the distance between adjacent identical parts of a sound wave. Just as the distance between adjacent crests in a transverse wave is one wavelength, the distance between adjacent compressions in a sound wave is also one wavelength, as shown in Figure 14.7. The frequency of a sound wave is the same as that of the source. For example, a tuning fork vibrating at a given frequency would produce sound waves that oscillate at that same frequency. The frequency of a sound is the number of waves that pass a point per unit time.

Figure 14.7 A sound wave emanates from a source vibrating at a frequency f, propagates at v, and has a wavelength $λλ$.

One of the more important properties of sound is that its speed is nearly independent of frequency. If this were not the case, and high-frequency sounds traveled faster, for example, then the farther you were from a band in a football stadium, the more the sound from the low-pitch instruments would lag behind the high-pitch ones. But the music from all instruments arrives in cadence independent of distance, and so all frequencies must travel at nearly the same speed.

Recall that $v=fλv=fλ$, and in a given medium under fixed temperature and humidity, v is constant. Therefore, the relationship between f and $λλ$ is inverse: The higher the frequency, the shorter the wavelength of a sound wave.

The speed of sound can change when sound travels from one medium to another. However, the frequency usually remains the same because it is like a driven oscillation and maintains the frequency of the original source. If v changes and f remains the same, then the wavelength $λλ$ must change. Since $v=fλv=fλ$, the higher the speed of a sound, the greater its wavelength for a given frequency.

### Virtual Physics

#### Sound

This simulation lets you see sound waves. Adjust the frequency or amplitude (volume) and you can see and hear how the wave changes. Move the listener around and hear what she hears. Switch to the Two Source Interference tab or the Interference by Reflection tab to experiment with interference and reflection.

#### Tips For Success

Make sure to have audio enabled and set to Listener rather than Speaker, or else the sound will not vary as you move the listener around.

Grasp Check
In the first tab, Listen to a Single Source, move the listener as far away from the speaker as possible, and then change the frequency of the sound wave. You may have noticed that there is a delay between the time when you change the setting and the time when you hear the sound get lower or higher in pitch. Why is this?
1. Because, intensity of the sound wave changes with the frequency.
2. Because, the speed of the sound wave changes when the frequency is changed.
3. Because, loudness of the sound wave takes time to adjust after a change in frequency.
4. Because it takes time for sound to reach the listener, so the listener perceives the new frequency of sound wave after a delay.
Is there a difference in the amount of delay depending on whether you make the frequency higher or lower? Why?
1. Yes, the speed of propagation depends only on the frequency of the wave.
2. Yes, the speed of propagation depends upon the wavelength of the wave, and wavelength changes as the frequency changes.
3. No, the speed of propagation depends only on the wavelength of the wave.
4. No, the speed of propagation is constant in a given medium; only the wavelength changes as the frequency changes.

### Snap Lab

#### Voice as a Sound Wave

In this lab you will observe the effects of blowing and speaking into a piece of paper in order to compare and contrast different sound waves.

Materials
• sheet of paper
• tape
• table

Instructions

Procedure
1. Suspend a sheet of paper so that the top edge of the paper is fixed and the bottom edge is free to move. You could tape the top edge of the paper to the edge of a table, for example.
2. Gently blow air near the edge of the bottom of the sheet and note how the sheet moves.
3. Speak softly and then louder such that the sounds hit the edge of the bottom of the paper, and note how the sheet moves.
4. Interpret the results.
Grasp Check

Which sound wave property increases when you are speaking more loudly than softly?

1. amplitude of the wave
2. frequency of the wave
3. speed of the wave
4. wavelength of the wave

### Worked Example

#### What Are the Wavelengths of Audible Sounds?

Calculate the wavelengths of sounds at the extremes of the audible range, 20 and 20,000 Hz, in conditions where sound travels at 348.7 m/s.

### STRATEGY

To find wavelength from frequency, we can use $v=fλv=fλ$.

Solution

(1) Identify the knowns. The values for v and f are given.

(2) Solve the relationship between speed, frequency and wavelength for $λλ$.

14.2$λ=vf.λ=vf.$

(3) Enter the speed and the minimum frequency to give the maximum wavelength.

14.3

(4) Enter the speed and the maximum frequency to give the minimum wavelength.

14.4
Discussion

Because the product of f multiplied by $λλ$ equals a constant velocity in unchanging conditions, the smaller f is, the larger $λλ$ must be, and vice versa. Note that you can also easily rearrange the same formula to find frequency or velocity.

# Practice Problems

### Practice Problems

What is the speed of a sound wave with frequency $2000Hz$ and wavelength $0.4m$?
1. $5×103m/s$
2. $3.2×102m/s$
3. $2×10−4m/s$
4. $8×102m/s$
Dogs can hear frequencies of up to $45kHz$. What is the wavelength of a sound wave with this frequency traveling in air at $0∘C$?
1. $2.0×107m$
2. $1.5×107m$
3. $1.4×102m$
4. $7.4×10−3m$

Exercise 1
What is a rarefaction?
1. Rarefaction is the high-pressure region created in a medium when a longitudinal wave passes through it.
2. Rarefaction is the low-pressure region created in a medium when a longitudinal wave passes through it.
3. Rarefaction is the highest point of amplitude of a sound wave.
4. Rarefaction is the lowest point of amplitude of a sound wave.
Exercise 2

What sort of motion do the particles of a medium experience when a sound wave passes through it?

1. Simple harmonic motion
2. Circular motion
3. Random motion
4. Translational motion
Exercise 3

What does the speed of sound depend on?

1. The wavelength of the wave
2. The size of the medium
3. The frequency of the wave
4. The properties of the medium
Exercise 4

What property of a gas would affect the speed of sound traveling through it?

1. The volume of the gas
2. The flammability of the gas
3. The mass of the gas
4. The compressibility of the gas